NEC Electra Elite IPK II System - Page 572

Document Revision 4C Electra Elite IPK II
2 - 548 IP Station (MEGACO) – MG 16
IP Extension Numbering:
 11-02-01 Extension Numbering
Define the IP Phone extension Number.
 This designated extension is used to register your IP Phone and is programmed IP Phone programming.
Refer to the Installation Instructions for Elite ITH-4D/8D/16D-2/3 Dterm IPK Terminals and the IP-R
(IPK) Adapters.
IP Phone Codec Information Basic Setup:
 84-03-10 IP Phone Information Basic Setup – Signaling Server Port
(default: 5029).
 84-11-01 D
term
IP CODEC Information Basic Setup – G.711 Audio Frame
Define the G.71 audio Frame Size [1 = 10 ms, 2 = 20 ms, 3 = 30 ms].
(default: 3)
 84-11-02 D
term
IP CODEC Information Basic Setup – G.711 VAD Mode
Enable/Disable Voice Activity Detection for G.711.
(default: 0:Disable)
 84-11-03 D
term
IP CODEC Information Basic Setup – G.711 Type
Define the G.711 Type – law is recommended when in USA.
(default: 1: -Law)
 84-11-04 D
term
IP CODEC Information Basic Setup – G.711 Jitter Buffer Min
Define G.711 Jitter Buffer minimum accepted value.
(default: 30 ms)
 84-11-05 D
term
IP CODEC Information Basic Setup – G.711 Jitter Buffer Average
Define G.711 Jitter Buffer average accepted value.
(default: 60 ms)
 84-11-06 D
term
IP CODEC Information Basic Setup – G.711 Jitter Buffer Max
Define G.711 Jitter Buffer maximum accepted value.
(default: 120 ms)
 84-11-07 D
term
IP CODEC Information Basic Setup – G.729 Audio Frame
Define the G.729 audio Frame Size (1 = 10 ms, 2 = 20 ms, 3 = 30 ms).
(default: 3=30 ms)
 84-11-08 D
term
IP CODEC Information Basic Setup – G.729 VAD Mode
Enable/Disable Voice Activity Detection for G.729.
(default: 0: Disable)
 84-11-09 D
term
IP CODEC Information Basic Setup – G.729 Jitter Buffer Min
Define G.711 Jitter Buffer minimum accepted value.
(default: 30 ms)