NEC Electra Elite IPK II System - Page 575

Electra Elite IPK II Document Revision 4C
IP Station (MEGACO) – MG 16 2 - 551
2. IP Address = 192.168.1.200
3. Subnet Mask = 255.255.255.0
4. MGC Address = 192.168.1.21, Ext = 100
Example Configuration 2 – Dynamic IP Addressing, One LAN:
This example shows System IP Phones connected to a single LAN (no routers) with a dynamic IP
address. The DHCP server could be:
 Customer supplied (i.e., Windows 2003 Server, etc.)
 Elite IPK II internal DHCP server
In this case, additional programming would be required.
Programming – IPK II CPUII
1. 10-12-01 CPUII Network Setup – IP Address = 192.168.1.20
2. 10-12-02 CPUII Network Setup – Subnet Mask = 255.255.255.0
Programming – System IP Phones
1. DHCP Mode – Enabled
Figure 2-12 Example – Dynamic IP Addressing, One LAN
IPK II CPUII
VoIP MG16
Switch/Hub
IP Phone 1
(DHCP)
IP Phone 2
(DHCP)
IPK II CPU: 192.168.1.20
VoIP MG16: 192.168.1.21
Subnet Mask:255.255.255.0
Default Gateway: 192.168.1.254