NEC Electra Elite IPK II System - Page 576

Document Revision 4C Electra Elite IPK II
2 - 552 IP Station (MEGACO) – MG 16
Example Configuration 3 – Static IP Addressing, Routed LAN:
This example shows System IP Phones connected to an Elite IPK II over a Wide Area Network (WAN)
with static addressing. This is a typical scenario – a small branch office connecting to an Elite IPK II at
the main office.
Programming – IPK II CPUII
1. 10-12-01 CPUII Network Setup – IP Address = 192.168.1.20
2. 10-12-02 CPUII Network Setup – Subnet Mask = 255.255.255.0
3. 10-12-03 CPUII Network Setup – Default Gateway = 192.168.1.254
Programming – VoIP MG16
1. 84-05-01 VoIP MG16 IP Address Setup (Slot No.) = 192.168.1.21
Programming – System IP Phones
1. DHCP Mode – Disabled
Figure 2-13 Example – Static IP Addressing, Routed WAN
IPK II CPUII
VoIP MG16
Switch/Hub
IP Phone 1/101
192.168.2.201
IPK II CPU: 192.168.1.20
VoIP MG16: 192.168.1.21
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
IP Phone 1/100
192.168.2.200
Router
192.168.1.254
WAN
(Leased line,
Frame Relay,
etc.)
Router
192.168.2.254
Switch/Hub