NEC Electra Elite IPK II System - Page 591

Electra Elite IPK II Document Revision 4C
IP Station (SIP) – MG16 2 - 567
 84-19-09 SIP Extension IP CODEC Information Basic Setup – G.729 Jitter Buffer (min)
Define G.711 Jitter Buffer minimum accepted value.
(default: 30 ms)
 84-19-10 SIP Extension IP CODEC Information Basic Setup – G729 Jitter Buffer (average)
Define G.729 Jitter Buffer setting.
(default: 60 ms)
 84-19-11 SIP Extension IP CODEC Information Basic Setup – G729 Jitter Buffer (max)
Define G.729 Jitter Buffer maximum accepted value.
(default: 120 ms)
 84-19-17 SIP Extension IP CODEC Information Basic Setup – Jitter Buffer Mode
Define the Jitter Buffer mode – support Static (1), Adaptive during silence (2), or Adaptive
Immediate (3).
(default: 3)
 84-19-18 SIP Extension IP CODEC Information Basic Setup – VAD Threshold
Define the VAD Threshold. Consult the Electra Elite IPK II Programming Manual for Threshold
scale to set acceptable values.
[default: 20 = 0dB (-30dBm)]
 84-19-26 SIP Extension IP CODEC Information Basic Setup – TX Gain
Define to TX Gain Values – Adjusting this value increases or decreases volume levels for the
receiving party. Consult the Electra Elite IPK II Programming Manual for Transmit Gain scale to
set acceptable value.
(default: 10)
 84-19-27 SIP Extension IP CODEC Information Basic Setup – RX Gain
Define to RX Gain Values – Adjusting this value increases or decreases volume levels for the
sending party. Consult the Electra Elite IPK II Programming Manual for Transmit Gain scale to
set acceptable value.
(default: 10)
 84-19-28 SIP Extension IP CODEC Information Basic Setup – Audio Capability Priority
Define Audio Capability Priority. Consult the Electra Elite IPK II Programming Manual for
Transmit Gain scale to set acceptable value.
(default: G.711)
 84-19-31 SIP Extension IP CODEC Information Basic Setup – DTMF Payload Number
Define the DTMF Payload Number.
(default: 110)
SIP Extension Basic Information Setup:
 84-20-01 SIP Extension Information Basic Setup – Registrar/Proxy Port
Define SIP station Proxy Port (0~65535).
(default: 5070)