NEC Electra Elite IPK II System - Page 592

Document Revision 4C Electra Elite IPK II
2 - 568 IP Station (SIP) – MG16
 84-20-02 SIP Extension Information Basic Setup – Session Timer Value
Define the periodic refresh time (0~65535 seconds) that allows both user agents and proxies to
determine if the SIP session is still active.
(default: 180)
 84-20-03 SIP Extension Information Basic Setup – Minimum Session Timer Value
Define the minimum allowed time (0~65535 seconds) for the SIP session timer.
(default: 180)
 84-20-04 SIP Extension Information Basic Setup – Called Party Info
Define the SIP Extension presented Caller ID information as Request URI (0) or To header (1).
(default: 0)
 84-20-05 SIP Extension Information Basic Setup – Expire Value of Invite
Define the time out response value (0~256 seconds) for SIP invite.
(default: 60)
IP Phone Configuration
IP Telephone Terminal Basic Data Setup:
 15-01-01 Basic Extension Data Setup – Extension Name
Review the type protocol support by the IP Phone.
(default: MEGACO)
 15-05-02 IP Telephone Terminal Basic Data Setup – IP Phone Fixed Port Assignment
Review the registered IP Phone Mac Address.
(default: 00-00-00-00-00-00)
 15-05-06 IP Telephone Terminal Basic Data Setup – IP Phone Terminal Type
Define the type of IP Phone being used – valid options are IP70 (1), IP80 (2) or IP Smart Phone
(3).
(default: 0)
 15-05-07 IP Telephone Terminal Basic Data Setup – Using IP Address
Review the registered IP Phones IP Address [Informational Only].
(default: 0.0.0.0)
 15-05-15 IP Telephone Terminal Basic Data Setup – CODEC Type
Set the registered IP Phone Codec type – Reference PRG 84-11 Dterm IP Codec Basic
Information.
(default: Type:1)
 15-05-16 IP Telephone Terminal Basic Data Setup – Authentication Password
Set the registered Basic Information.
(default: Not Assigned)
 15-05-17 IP Telephone Terminal Basic Data Setup – Calling Party Display Info
Set the Calling Party Display as Nickname (0), Display Name (1), User Part (2), or Extension (3).
(default: 0)