Electra Elite IPK II Document Revision 4C
ISDN Compatibility 2 - 643
10-06-02 ISDN BRI Setup – DID Mode
Select the method the system uses when assigning DID Mode to the BRI Circuit.
0 = Route by Called Party Number (default).
1 = Route by Redirecting Number
10-06-03 ISDN BRI Setup – SPID 1
Assign the SPID Number for B-Channel 1 (maximum of 20 Digits allowed).
10-06-04 ISDN BRI Setup – SPID 2
Assign the SPID Number for B-Channel 2 (maximum of 20 Digits allowed).
21-12-01 ISDN Calling Party Number Setup for Trunks – Calling Party Number Data
Assign Calling Party Numbers for each trunk (maximum 16 digits per entry).
After the above programming is complete a reset of the BRT(4)-U20 ETU is required.
ISDN – PRI Installation
10-03-01 ETU Setup – For BRI PKG
Set up and confirm the Basic Configuration data for each DTI ( )-U40 ETU. Use this program to
select the ISDN Line Mode.
0 = Not Set
1 = T-Bus (Default)
10-03-03 ETU Setup – Connection Type (For BRI PKG)
Set up and confirm the Basic Configuration data for each DTI( )-U40 ETU. This program
determines whether or not the CRC Multi-frame (CRC4) is used.
0 = Off (Default)
1 = On
10-03-04 ETU Setup (for PRI PKG Setup) – Layer 3 Timer Type
Set up and confirm the Basic Configuration data for each DTI-U40 ETU. This program selects
the Layer 3 timer type (1~5). Each timer value of Layer 3 is set up for each type in Program
81-06 (T-Bus).
10-03-06 ETU Setup (for PRI PKG Setup) – Length of Cable
Set up and confirm the Basic Configuration data for each DTI-U40 ETU. Select the length of
cable to be used.
0 = 0 ~ 40m (Default)
1 = 40 ~ 81m
2 = 81 ~ 122m
3 = 122 ~ 162m
4 = 162 ~ 200m
To Next Page
Loading...
