NEC Electra Elite IPK II System - Page 709

Electra Elite IPK II Document Revision 4C
Line Preference 2 - 685
 15-01-02 Basic Extension Data Setup – Outgoing Trunk Line Preference
Enable (1)/Disable (0) Outgoing Trunk Line Preference for extensions.
 15-02-10 Multiline Telephone Basic Data Setup – Ringing Line Preference for Trunk Calls
Enable Idle (0)/Ringing (1) Line Preference for trunk calls. Program 22-01-01 sets Intercom (0)
or trunk (1) call priority.
 15-06-01 Trunk Access Map for Extensions
For Outgoing Line Preference and Auto-Answer of Non-Ringing Lines, assign trunk Access
Maps to extensions.
Trunk Access Maps: 1~200
 20-10-07 Class of Service Options (Answer Service) – Automatic Off-Hook Answer
Enable (1)/Disable (0)) an extension user ability to use Universal Auto Answer for non-ringing
lines.
 22-01-01 System Options for Incoming Calls – Incoming Call Priority
Determine if ringing Intercom calls (0) or ringing trunk calls (1) should have answer priority.
 22-04-01 Incoming Extension Ring Group Assignment
Assign extensions to ring groups. Auto-Answer for Non-Ringing Lines only works for trunks that
do not ring an extension.
Ring Groups:
1~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
 22-05-01 Incoming Trunk Ring Group Assignment
Assign trunks to ring groups. Auto-Answer for Non-Ringing Lines only works for trunks that do
not ring an extension.
Ring Groups:
1~100
102 = In-Skin/External Voice Mail
103 = Centralized Voice Mail
 23-03-01 Universal Answer/Auto Answer
For each extension, select the route that it uses for Auto-Answer for Non-Ringing Lines. The
routes correspond to the Trunk Group Routing table set in Program 14-06.
Trunk Group Routes: 1~100