NEC Electra Elite IPK II System - Page 74

Document Revision 4C Electra Elite IPK II
2 - 50 Analog Communications Interface (ACI)
 15-12-01 Conversation Recording Destination for Extensions – ACI Recording Destination
Extension Number
Assign the ACI Call Recording destination per extension. The destination can be an ACI port
extension number (assigned in Program 11-06) or an ACI Department Group pilot number
(assigned in Program 11-08). If destinations are assigned in PRG 14-09 and PRG 15-12, the
destination in PRG 15-12 is followed.
 15-12-02 Conversation Recording Destination for Extensions – ACI Automatic
Recording for Incoming Calls
Determine whether or not an extension should be automatically recorded when an incoming call
is received.
0 = Off
1 = On
 33-01-01 ACI Port Type Setup – ACI Type
Set each ACI software port for input (1) or input/output (2). Use input ports for Music on Hold
sources. Use output ports for External Paging/ringer control.
ACI Ports: 1~96
 33-02-01 ACI Department Calling Group – Group Number
Assign ACI software ports to ACI Department Groups. This lets ACI callers connect to ACI
software ports by dialing the group’s pilot number (set in Program 11-08).
ACI Ports: 1~96
ACI Groups: 1~16
Operation
To call an ACI software port:
1. Press idle Speaker.
2. Dial ACI software port extension number.
- OR -
Dial ACI Department Group extension number.
- OR -
Press the One-Touch Key for ACI extension or Department Group.