NEC Electra Elite IPK II System - Page 761

Electra Elite IPK II Document Revision 4C
Music on Hold 2 - 737
Programming
Start
In 14-08-01,
enter 0.
Should a trunk use the
CPU, or the external
source connected to the
BGM or ACI port for
MOH?
In 10-03-01, confirm the
PGD(2)-U10 ADP to be used
for external music source is
recognized and has type 9
assigned.
CPU
ACI Port
BGM Port
Should the CPU
use the internal or
external source?
In 14-08-01, enter 1.
In 10-04-01,
enter 0.
In 10-04-01,
enter 1.
In 10-04-03, adjust the
audio gain setting
(1~63).
In 14-08-01,
enter 2.
In 11-06-01, assign an extension
number to the ACI port. Select a
number outside the normal
extension number range (e.g.,
400).
In 33-02-01, assign ACI
software ports (1~96) to an
ACI Department Group
(1~16).
Is the MOH
gain
acceptable?
Stop
In 10-21-01, set the
external relay to 1.
In 14-08-02. enter the ACI
source port number (1~96)
for each trunk.
In 33-01-01, set the ACI
port to 1.
Internal
No
Note: Other ACI programming may be
necessary. Refer to Analog Communications
Interface (ACI) on page 2-45.
External
In 11-08-01. assign a pilot
number to the ACI group.