Document Revision 4C Electra Elite IPK II
2 - 738 Music on Hold
10-04-01 Music on Hold Setup – Music on Hold Source Selection
Determine whether the system should use No Tone (0), External (1) Music Source, or Internal
Service Tone (2). If set to 1, Program 14-08-01 must be set to 0 or 1.
(default: 2)
10-04-03 Music on Hold Setup – Audio Gain Setup
Set the Music on Hold audio gain (1~63).
[default: 32 (0dB)]
14-08-01 Music on Hold Source for Trunks – MOH Type
For each trunk, set the Music on Hold source.
0 = Internal/External MOH
1 = Customer Provided Source Connected to BGM Port
2 = Customer Provided Source Connected to ACI Port
(default: 0)
14-08-02 Music on Hold Source Port Number – Source Port Number
If the MOH type is 2 in PRG 14-08-01, for each trunk enter the ACI source port number (0~96).
(default: 0)
33-01-01 ACI Port Type Setup
If ACI software port is designated for MOH in PRG 14-08-01, set port function to 1 (input).
(default: 2)
80-01-01 Service Tone Setup, Music On Hold Tone (Service Tone 64)
If required, change the tone heard by the user when placed on hold when Program 10-04-01 set
to 2.
[default: 32 (0dB)]
When Using a PGD(2)-U10 ADP:
10-03-01 ETU Setup – Terminal Type (B1) for ESI PKG
If a PGD(2)-U10 ADP is used for the external music source, the module is automatically
assigned type 9 if the jumper straps in the module are set prior to connecting it to the system. If
another type is assigned, disconnect the PGD(2)-U10 ADP from the system, delete the type
setting, and, with the jumper straps positioned correctly in the PGD(2)-U10 ADP, reconnect the
module to the system. Refer to the Electra Elite IPK II System Hardware Manual for the jumper
strap settings.
11-06-01 ACI Extension Numbering
Each ACI port must be assigned an extension number. Use this program to assign the extension
numbers to ACI software ports. Select a number outside of the normal extension number range.
ACI Ports: 1~96
(default: No extensions assigned)
11-08-01 ACI Group Pilot Number
Assign pilot numbers to ACI groups. When a user dials the pilot number, they reach an available
ACI software port in the group.
.
ACI Groups: 1~16
(default: No Setting)
To Next Page
Loading...
