NEC Electra Elite IPK II System - Page 787

Electra Elite IPK II Document Revision 4C
One-Touch Calling 2 - 763
Operation
Programmable Function Keys
To define a Programmable Function Key as a One-Touch Key:
1. Dial the service code for Function Key Programming (PRG 11-11-17, 751 by default).
2. Press the key to be defined.
3. Dial 01 (DSS/One-Touch Key Operation).
4. For Direct Station Selection (Extension):
a. Dial extension number you want assigned to that key.
b. Press Hold.
c. Press Speaker.
For Personal Speed Dial:
a. Dial the general trunk access code (9).
- OR -
Dial the Specific Trunk Service Code (#9) plus the trunk number (e.g., 005).
- OR -
Dial the Trunk Group Service Code (704) plus the trunk group number (e.g., 1).
b. Dial the number you want to store.
 The total of the digits stored in steps 3 and 4 cannot exceed 24.
 Valid entries are 0~9, # and . To enter a pause, press MIC. To store a Flash, press the Redial key.
c. Press Hold.
d. Press Speaker.
For Speed Dial – System/Group:
a. Dial #2 to store a Speed Dial – System dialing number.
- OR -
Dial #4 to store a Speed Dial – Group dialing number.
b. Dial Speed Dial number storage code (e.g., 001).
c. Press Hold.
d. Press Speaker.