Document Revision 4C Electra Elite IPK II
2 - 816 Programmable Function Keys
If the feature key is not listed below, the LCD shows ALL-BLANK. (PRG 15-07-01 Line
Key Assign).
One-Touch keys programmed for Park Hold Service Code cannot be used to park calls
without first using Hold or Transfer.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered
as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ symbol can be entered in the dial string of a DSS/One Touch button. The @ only
applies to ISDN and Intercom calls. When using @, the system waits for the destination to
answer (answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom
calls, or after @ for ISDN calls.
Default Setting
The first eight keys on a telephone are line keys (e.g., key 1 = line 001). The remaining keys are
unassigned.
Function
Number
Function Display
00 None [All Blank]
01 DSS/One-Touch DSS (xxxxxxxx xxxxxxxx = Extension Number
02 Microphone Key (ON/OFF) MIC
03 DND Key DND
04 BGM (ON/OFF) BGM
05 Headset HSET
07 Conference Key CONF
10 Call Forward – Immediate CFA
11 Call Forward – Busy CFB
12 Call Forward – No Answer CFNA
13 Call Forward – Busy/No Answer CFBNA
14 Call Forward – Both Ring CFBOTH
15 Follow Me FLWME
If a key is programmed as a DSS/One-Touch key for a station that is set for Call Forward All
Calls or Do Not Disturb, the DSS/One-Touch key flashes. If a station is busy, the DSS/
One-Touch for that station does not light solid, even if Call Forward All Calls or DND is set.
Refer to the Electra Elite IPK II Programming Manual for a complete list of Function
Numbers.
To Next Page
Loading...
