NEC Electra Elite IPK II System - Page 926

Document Revision 4C Electra Elite IPK II
2 - 902 Speed Dial – System/Group/Station
 13-01-01 Speed Dialing Option Setup – Speed Dialing Auto Outgoing Call Mode
Designate trunk or intercom outgoing mode.
(default: 0, trunk)
 13-01-03 Speed Dialing Option Setup – Number of Common Speed Dialing Bins
Designate the bins the system uses for System Speed Dialing.
(default: 1000)
 13-02-01 Group Speed Dialing Bins
Designate the bins the system uses for Group Speed Dialing.
(default: No Setting)
 13-03-01 Speed Dialing Group Assignment for Extensions
For Group Speed Dialing, assign extensions to Speed Dialing groups (1~64).
(default: 1)
 13-04-01 Speed Dialing Number and Name – Speed Dialing Data
Enter the System and Group Speed Dialing numbers and names.
(default: No Setting)
 13-04-02 Speed Dialing Number and Name – Name
Assign a name to each System Speed Dial bin.
(default: No Setting)
 13-04-03 Speed Dialing Number and Name – Transfer Mode
Assign the transfer mode for each System Speed Dial bin.
(default: 0)
 13-04-04 Speed Dialing Number and Name – Transfer Destination Number
(default: No Setting)
 13-04-05 Speed Dialing Number and Name – Incoming Ring Pattern
(default: 0)
 13-05-01 Speed Dialing Trunk Group – Trunk Group Number
For each System Speed Dialing number, enter the routing option Trunk Group Number (1~100)
to dial out on.
(default: No Setting)
 14-02-06 Analog Trunk Data Setup – Pause at 1st digit after Line Seize in Manual Dial Mode
Enable (1)/Disable (0) the system ability to pause after dialing the first digit.
(default: 1)
 15-02-04 Multiline Telephone Basic Data setup – Redial (Speed Dial ) Control
Assign the extension Redial key for either Common (0) or Group (1) Speed Dialing.
(default: 0)