NEC Electra Elite IPK II System - Page 980

Document Revision 4C Electra Elite IPK II
2 - 956 Tandem Trunking (Unsupervised Conference)
Required Component(s)
None
Related Features
Call Forwarding, Off-Premise
Central Office Calls, Answering
Central Office Calls, Placing
Direct Inward System Access (DISA)
Programming
Tandem Trunking Method A – Tandem Trunking from Conference
 11-12-57 Service Code Setup (for Service Access) – Tandem Trunking
If the default service code (#8) for Tandem Trunking is not acceptable, change the code as
required.
 14-01-04 Basic Trunk Data Setup – Transmit Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-05 Basic Trunk Data Setup – Receive Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-13 Basic Trunk Data Setup – Trunk-to-Trunk Transfer
For each trunk that should be able to participate in a tandem call, enter 1.
 15-07-01 Programmable Function Keys
(Optional) Assign a function key for Transfer (code 06).
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-07-11 Class of Service Options (Administrator Level) – Forced Trunk Disconnect (analog trunk
only)
Enter 1 to enable Forced Trunk Disconnect. This allows the extension to disconnect an
Unsupervised Conference in progress.
 20-11-14 Class of Service Options (Hold/Transfer Service) – Trunk-to-Trunk Transfer Restriction
Disable (0) the Trunk-to-Trunk Transfer Restriction option.