NEC Electra Elite IPK II System - Page 981

Electra Elite IPK II Document Revision 4C
Tandem Trunking (Unsupervised Conference) 2 - 957
 20-11-21 Class of Service Options (Hold/Transfer Service) – Restriction for Tandem Trunking on
Hang Up
Deny (1) an extension user ability to set up a tandem call automatically when they hang up.
(default: 0)
 20-11-22 Class of Service Options (Hold/Transfer Service) – Restricted Unsupervised Conference
Enable (1)/Disable (0) an extension user ability to initiate an unsupervised conference.
(default: 0)
 20-13-08 Class of Service Options (Supplementary Service) – Conference
Enable (1)/Disable (0) the extension ability to initiate a conference.
(default: 1)
 20-13-10 Class of Service Options (Supplementary Service) – Barge-In Monitor
Set whether an extension should be able to Barge-In to a call and talk (1) or just monitor the call
(0).
(default: 0)
 24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
This timer (0~64800 seconds) starts when a trunk begins talking with another trunk (for
example: Trunk-to-Trunk Transfer, outgoing from trunk, Tandem Trunking).
(default: 1800)
 24-02-10 System Options for Transfer – Disconnect Trunk-to-Trunk
This timer (0~64800 seconds) starts after the Trunk-to-Trunk warning tone is heard.
(default: 0)
 25-07-07 System Timers for VRS/DISA – Ling Conversation Warning Tone Time
Determine the time (0~64800 seconds) a DISA caller or a Tandem Trunking conversation can
talk before the Long Conversation tone is heard.
(default: 3600)
 25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
This timer (0~-64800 seconds determines the time the system waits before disconnecting a call
after the Long Conversation tone is heard.
(default: 10)
Tandem Trunking Method B – Tandem Trunking with Transfer Key
 14-01-04 Basic Trunk Data Setup – Transmit Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-05 Basic Trunk Data Setup – Receive Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-13 Basic Trunk Data Setup – Trunk-to-Trunk Transfer
For each trunk, enter 1 to enable loop supervision.
 15-07-01 Programmable Function Keys
Assign a function key for Transfer (code 06).