NEC Electra Elite IPK II System - Page 982

Document Revision 4C Electra Elite IPK II
2 - 958 Tandem Trunking (Unsupervised Conference)
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-07-11 Class of Service Options (Administrator Level) – Forced Trunk Disconnect (analog trunk
only)
Enter 1 to enable Forced Trunk Disconnect. This allows the extension to disconnect an
Unsupervised Conference in progress (initially set up using Method B).
 20-11-14 Class of Service Options (Hold/Transfer Service) – Trunk-to-Trunk Transfer Restriction
Disable (0) the Trunk-to-Trunk Transfer Restriction option.
(default: 0)
 20-11-21 Class of Service Options (Hold/Transfer Service) – Restriction for Tandem Trunking on
Hang Up
Deny (1) an extension user ability to set up a tandem call automatically when they hang up.
(default: 0)
 20-13-10 Class of Service Options (Supplementary Service) – Barge-In Monitor
Set whether an extension should be able to Barge-In to a call and talk (1) or just monitor the call
(0).
(default: 0)
 24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
This timer (0~64800 seconds) starts when a trunk begins talking with another trunk (for
example: Trunk-to-Trunk Transfer, outgoing from trunk, Tandem Trunking).
(default:1800)
 24-02-10 System Options for Transfer – Disconnect Trunk-to-Trunk
This timer (0~64800 seconds) starts after the Trunk-to-Trunk warning tone is heard .
(default: 0)
 25-07-07 System Timers for VRS/DISA – Long Conversation Warning Tone Time
Determine the time (0~64800 seconds) a DISA caller or any trunk-to-trunk (such as Tandem
Trunking) conversation can talk before the Long Conversation tone is heard.
(default:3600)
 25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
This timer (0~64800 seconds) determines the time the system waits before disconnecting a
DISA or any trunk-to-trunk (such as Tandem Trunking) call after the Long Conversation tone is
heard.
(default: 10)
Tandem Trunking Method C – Tandem Trunking on Hang up
 14-01-04 Basic Trunk Data Setup – Transmit Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-05 Basic Trunk Data Setup – Receive Gain Level for Conference and Transfer Calls
Select the CODEC gain type used by the trunk when it is part of an Unsupervised Conference.
 14-01-13 Basic Trunk Data Setup – Trunk-to-Trunk Transfer
For each trunk, enter 1 to enable loop supervision.