NEC Electra Elite IPK II System - Page 983

Electra Elite IPK II Document Revision 4C
Tandem Trunking (Unsupervised Conference) 2 - 959
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-07-11 Class of Service Options (Administrator Level) – Forced Trunk Disconnect (analog trunk
only)
Enter 1 to enable Forced Trunk Disconnect. This allows the extension to disconnect an
Unsupervised Conference in progress (initially set up using Method B).
[default: 0 (COS 1~14); 1 (COS 15)]
 20-11-11 Class of Service Options (Hold/Transfer Service) – Auto On-Hook Transfer
Disable (0)/Enable (1) an extension user ability to transfer when the user hangs up.
(default: 0)
 20-11-14 Class of Service Options (Hold/Transfer Service) – Trunk-to-Trunk Transfer Restriction
Disable (0) the Trunk-to-Trunk Transfer Restriction option.
(default: 0)
 20-11-21 Class of Service Options (Hold/Transfer Service) – Restriction for Tandem Trunking on
Hang Up
Allow (0) an extension user to set up a tandem call automatically when they hang up.
(default: 0)
 24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
This timer (0~64800 seconds). starts when a trunk begins talking with another trunk (for
example: Trunk-to-Trunk Transfer, outgoing from trunk, Tandem Trunking)
(default: 1800)
 24-02-10 System Options for Transfer – Disconnect Trunk-to-Trunk
This timer (0~64800 seconds). starts after the Trunk-to-Trunk warning tone is heard.
 25-07-07 System Timers for VRS/DISA – Long Conversation Warning Tone Time
Determine the time a DISA caller or any trunk-to-trunk (such as Tandem Trunking) conversation
can talk before the Long Conversation tone is heard (0~64800 seconds).
(default: 3600)
 25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
This timer (0~64800 seconds). determines the time the system waits before disconnecting a a
DISA or any trunk-to-trunk (such as Tandem Trunking) call after the Long Conversation tone is
heard.
(default: 10)
Tandem Trunking Method D – Tandem Trunking to Speed Dial Number
 11-10-06 Service Code Setup (for System Administrator) – Setting the Automatic Transfer for Each
Trunk Line
If the default service code (733) for enabling Automatic Tandem Trunking feature is not
acceptable, change the code as required.
 11-10-07 Service Code Setup (for System Administrator) – Canceling the Automatic Transfer for
Each Trunk Line
If the default service code (734) for canceling Automatic Tandem Trunking feature is not
acceptable, change the code as required.