NEC UX5000 - Page 269

Chapter 4 - Terminals and Optional Equipment
Chapter 4 4 - 51
5. Install the adapter on the bottom of the
terminal.
6. Return the terminal to an upright
position and reconnect all the cables.
7. Plug the line cord back into the keyset.
8. Plug the end of the line cord for the
analog device into the jack on the
adapter. The opposite end should then
be connected to the analog device.
● To avoid any hardware
problems, when removing the
adapter, first unplug the line
cord, then the power cord, then
any other adapter cables.
● The analog device should be
placed no greater than 15
meters away from the keyset.
9. To determine the APR’s analog extension number . . .
10-03-06 : Blade Setup - Terminal Type
For Aspire Terminals Only (UX5000 terminals automatically assigned): Assign the terminal
type (12) for the keyset’s channel which has the APR Adapter installed.
For UX5000 or Aspire terminals, when you wish to have the APR use the same extension
number as the keyset to which it is attached (like an APA), remove the terminal type in this
option. With this setup, when the analog device is in use, it busies out the keyset as there is no
separate port number assigned for the adapter. To reverse this, and allow the APR to have its
own extension number, simply reassign the terminal type (12) in this option.
10-03-07 : Blade Setup - Logical Port Number
The port number of the APR Adapter is displayed for the extension (APR ports = 193-512).
The ports are assigned from the highest available port down. This option is read-only.
10-03-10 : Blade Setup - Bottom Option
Displays the type of terminal installed. This can be used to verify that the system recognizes
the adapter.
11-02-01 : Extension Numbering
To determine the extension number assigned for the APR device, refer to the table below.
Figure 4-27: INSTALL THE APR ADAPTER
APR Extension Port Number Extension Number
193 493
: :
199 499
200 5000
::
512 5312