HZ read group size
IMM PGM MIP
USAGE ♦ ♦ ♦
SYNTAX xxHZ
PARAMETERS
Description xx [ int ] - group number
Units xx - none
Range xx - 1 to MAX GROUPS
Defaults xx missing: error 13, GROUP NUMBER MISSING
out of range: error 14, GROUP NUMBER OUT OF RANGE
not assigned: error 15, GROUP NUMBER NOT ASSIGNED
DESCRIPTION This command is used to read the number of axes assigned to a group.
RETURNS This command reports the current setting.
REL. COMMANDS HN - create a new group
HX - delete a group
EXAMPLE 1HN1,2 | create a new group (#1) with physical axes 1 and 2
1HN? | read axes assigned to group #1
1,2 | controller returns the axes assigned to group #1
1HZ | read size of group #1
2 | controller returns 2
Section 3 – Remote Mode 3-85
To Next Page
Loading...
