VE read controller firmware version
PARAMETERS none
Defaults timeout: error 2, RS-232 COMMUNICATION TIME-OUT
Note:
IMM PGM MIP
USAGE ♦ ♦
SYNTAX VE ?
DESCRIPTION This command is used to read the controller type and version.
Important information needed when asking for technical support for the motion
control system or when reporting a problem is the controller version. Use this
command to determine the controller type and in particular, the firmware version.
RETURNS ESP300 Version xx.yy
where: xx.yy = version and release number
REL. COMMANDS none
EXAMPLE VE? | read controller firmware version
ESP300 Version 3.0.1 6/1/99 | controller returns model ESP300
| version 3.0 and release date 6/1/99
3-150 Section 3 – Remote Mode
To Next Page
Loading...
