QP quit program mode
IMM PGM MIP
USAGE ♦
SYNTAX QP
PARAMETERS None
DESCRIPTION This command quits the controller from programming mode. All the commands
following this one will be executed immediately.
RETURNS none
REL. COMMANDS EX - execute stored program
AP - abort stored program execution
XX - erase program
EXAMPLE 3XX | clear program 3 from memory, if any
3EP | activate program mode and enter following commands as
| program 3
•
•
•
QP | end entering program and quit programming mode
3EX | run stored program number 3
Section 3 – Remote Mode 3-117
To Next Page
Loading...
