SA set device address
IMM PGM MIP
USAGE ♦ ♦ ♦
SYNTAX SAnn or SA?
PARAMETERS
Description nn [ int ] - address number
Range nn - 1 to 30
Units nn - none
Defaults nn missing: error 38, COMMAND PARAMETER MISSING
out of range: error 7, PARAMETER OUT OF RANGE
Note:
DESCRIPTION This command is used to set and report the device (i.e., ESP controller) address
for use with IEEE-488 or USB communications (if equipped).
The address change takes affect immediately after the command is processed.
Use the SM command to save new address setting to non-volatile memory.
RETURNS If the “?” sign takes the place of nn value, this command reports the current
setting.
REL. COMMANDS none
EXAMPLE SA 3 | set device address to 3
SA ? | read present device address setting
3 | controller returns device address #3
SM | save all settings to non-volatile memory
Section 3 – Remote Mode 3-125
To Next Page
Loading...
