458
Network Connections
Problem Solution
The camera displays a TCP/IP
error.
Check settings for the host computer or
wireless router and adjust camera
settings appropriately (
0
696).
The camera displays a “no
memory card” error.
Confirm that the memory card is
correctly inserted (
0
27).
Upload is interrupted and fails
to resume.
Upload will resume if the camera is
turned off and then on again (
0
447).
The connection is unreliable.
If [Auto] is selected for [Channel],
choose [Manual] and select the channel
manually (
0
695).
If the camera is connected to a computer
in infrastructure mode, check that the
router is set to a channel between 1 and
8 (
0
696).
[Connect to smart device]
and [Connect to PC] are
grayed out and cannot be
selected.
These options are not available when
the WT-7 is connected. Turn the WT-7 off
(
0
700).
To Next Page
Loading...
