811
Technical Notes
●
Wireless Remote Controllers
•
WR-R10 Wireless Remote Controller/WR-T10 Wireless Remote
Controller: When a WR-R10 wireless remote controller is attached to
accessory terminal, the camera can be controlled remotely using a
WR-T10 wireless remote controller.
- The WR-R10 can also be used to control radio-controlled flash units.
- For synchronized release involving more than one camera, ready
multiple cameras with paired WR-R10 units attached.
* When connecting the WR-R10, be sure the covers for the accessory
terminal and the USB and HDMI connectors are fully open.
•
WR-1 Wireless Remote Controller: WR-1 units are used with WR-R10 or
WR-T10 wireless remote controllers or with other WR-1 remote
controllers, with the WR-1 units functioning as either transmitters or
receivers. When a WR-R10 or a WR-1 configured as a receiver is
connected to the camera accessory terminal, a WR-T10 or a second
WR-1 configured as a transmitter can be used to take pictures remotely.
Camera settings can also be adjusted using a WR-1 configured as a
transmitter.
* Be sure the firmware for the WR-R10 and WR-1 has been updated to the
latest versions (WR-R10 firmware version 3.0 or later and WR-1 firmware
version 1.0.1 or later). For information on firmware updates, see the
Nikon website for your area. Consult a Nikon-authorized service
representative when updating the firmware for the WR-R10 from
versions prior to version 2.0 to version 3.0 or later.
To Next Page
Loading...
