ACCESS GATEWAY
System Administration 89
2. Enter your location information in the following fields:
Company Name
Site Name
Address (Line 1 and Line 2)
City, State, Zip, and Country
E-mail Address
ISO Country Code
Phone Country Code
Calling Area Code
3. Select the area type that most resembles your location from the drop down list.
4. Enter a Network SSID/Zone.
5. To enable the 802.1Q tag for:
System traffic, check the box Enable WAN 802.1Q header for System Traffic, and
if necessary, enter the tag number.
Subscribers traffic, check the box Enable WAN 802.1Q header for Subscribers
Traffic
, and if necessary, enter the tag number..
Changing these settings could result in loss of connectivity.
Changing these settings could result in loss of connectivity.
You must reboot the system if you make changes to any of the following IP
settings.
You may lose your connection if you change the IP settings incorrectly (using
invalid IP addresses). If you “misconfigure” the Access Gateway and network
connectivity is lost, you can still access the Access Gateway from the Command
Line Interface (CLI) via a direct serial connection. In this case, refer to:
Powering Up the System and “Logging In” on page 53.
To Next Page
Loading...
