Nomadix Access Gateways - Powering up the System

ACCESS GATEWAY
28 Installing the Access Gateway
Powering Up the System
Use this procedure to establish a direct cable connection between the Access Gateway and your
laptop computer, and to power up the system.
1. Place the Access Gateway on a flat and stable work surface.
2. Connect the power cord.
3. Connect the DB9 serial cable between the Access Gateway’s “serial port” or "front Access
RJ45 port" and your computer.
4. Turn on your computer and allow it to boot up.
5. Turn on the Access Gateway.
Connect the serial
cable here
(On other platforms,
connection may be via
front-access RJ45 port).