ACCESS GATEWAY
70 System Administration
1. From the Web Management Interface, click on Configuration, then Bandwidth
Management. The Bandwidth Management screen appears:
2. If required, click the check box for Bandwidth Management Enabled (this field is not
available on the AG 2300 platform because Bandwidth Management is always enabled).
3. If you enabled Bandwidth Management, enter the uplink and downlink speeds (in Kbps) in
the appropriate fields.
4. If you made any changes to the settings on this screen, you must click the check box for
Reboot after changes are saved? (the Access Gateway must be rebooted).
5. Click on the Submit button to save your changes and reboot the system, or click on the
Reset button if you want to reset all the values to their previous state.
Establishing Billing Records “Mirroring” {Bill Record Mirroring}
The Access Gateway can send copies of credit card transaction and PMS billing records to
external servers that have been previously defined by system administrators. The Access
Gateway assumes control of billing transmissions and saving billing records. By “mirroring”
the billing data, theAccess Gateway can also send copies of billing records to predefined
“carbon copy” servers. Additionally, if the primary and secondary servers are down, the Access
Gateway can store up to 2,000 credit card transaction records. When a connection is re-
Setting the uplink or downlink speeds to anything greater than what your product
supports is prevented by the NSE. Please refer to “Product Specifications” on
page 252 for your product’s capabilities.
To Next Page
Loading...
