Nomadix Access Gateways - Selected Detailed Descriptions

ACCESS GATEWAY
270 Quick Reference Guide
 Acct-Session-Time (Stop)
 Terminate-Cause (Stop)
 NAS ID
 NAS-IP Address
 NAS-Port-Type
 NAS-Port
 Framed-IP Address
 Acct-Delay-Time
 Called-Station-ID
 Calling-Station-ID
Selected Detailed Descriptions
Acct-Session-ID
The Acct-Session-ID is created when the RADIUS authentication request is built. It is
transmitted in both the Access-Request and the Accounting-Request.
Session Timeout
There is currently no default session timeout that you can set in the Access Gateway Web
Management Interface (WMI). If the Radius server does not send a Session-Timeout, the
Access Gateway will set the subscriber expiration time to 0, which means access forever.
Log-Off-URL
Allows for the placement of a log off URL (for example, 1.1.1.1) on an external portal page.
Idle Timeout
The WMI allows the setting of a default timeout. If the Radius server does not send an Idle-
Timeout in the Radius Access-Accept, the Access Gateway will use the default one to
disconnect subscribers. “0” means forever.
Timeout Detection
If a subscriber is sending traffic through the Access Gateway, the Access Gateway will
immediately detect a Session-Timeout. However in the case of an Idle-Timeout or an inactive
subscriber Session-Timeout, the Access Gateway detects it via a clean-up function that is
currently called every 2 minutes. Thus the current precision for sending the Acct-Stop is about
2 minutes.