Nomadix Access Gateways - Defining Subscriber UI Buttons {Subscriber Buttons

ACCESS GATEWAY
200 System Administration
2. Click on the Enable IWS Goodbye Page check box to enable (or disable) the IWS
Goodbye Page, as required.
3. If you enabled the IWS Goodbye Page, select your preferred display options by checking
the corresponding boxes:
 Display IP Address
 Display Authen Type
 Display Start Time
 Display Stop Time
 Display Byte Sent
 Display Byte Received
 Display Hypertext Link URL
4. If you enabled the Hypertext Link URL feature, enter the URL for the link in the Hyper
Text Link URL
field.
5. Define the following Field Label Definitions for your Goodbye Page:
 Session Summary
 IP Address
 Authen Type
 Start Time
 Stop Time
 Byte Sent
 Byte Received
 Go To
6. Click on the Submit button to save your changes. Alternatively, you can click on the
Reset button to reset all values to their previous state, or click on the Revert button to
revert all values to their default state.
Defining Subscriber UI Buttons {Subscriber Buttons}
This procedure allows you to define how each of the control buttons are displayed to
subscribers.
If you enabled the Partner image for the Login UI, you will also see the same
image in the IWS Post Session page.