Nomadix Access Gateways - Adding Static Ports {Static Port-Mapping Add

ACCESS GATEWAY
System Administration 223
1. From the Web Management Interface, click on System, then Session Limit. The Session
Rate Limiting screen appears:
2. Click on the check box for Session Rate Limiting to enable (or disable) this feature, as
required.
3. Enter values for the following session “limiting” parameters:
 Mean Rate
 Burst Size
 Time Interval (in seconds)
4. Click on the Submit button to save your changes.
For advanced security, see also “Defining the MAC Filtering Options {Mac Filtering}” on
page 219.
Adding Static Ports {Static Port-Mapping Add}
Static Port-Mapping allows the network administrator to setup a port mapping scheme that
forwards packets received on a specific port to a particular static IP (typically private and mis-
configured) and port number on the subscriber side of the Access Gateway. The advantage for
the network administrator is that free private IP addresses can be used to manage devices (such
as Access Points) on the subscriber side of the Access Gateway without setting them up with
public IP addresses.
This procedure shows you how to add static ports.