ACCESS GATEWAY
Installing the Access Gateway 29
Logging In to the Command Line Interface
Use this procedure to initialize the system and log in to the Access Gateway’s Command Line
Interface (CLI). The character-based CLI is used at initial start-up.
1. Start a HyperTerminal™ session to connect to the Access Gateway. Use the following
HyperTerminal settings:
2. When connected to the Access Gateway, a login prompt appears on your screen.
The default login user name is “admin.” The password is “admin.” Login names and
passwords are case-sensitive.
3. Enter admin when prompted for a user name and password. The Access Gateway Menu
appears when you have logged in to the Access Gateway’s management interface
successfully. If this is an initial installation which requires the Access Gateway to receive
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
To Next Page
Loading...
