Nomadix Access Gateways - System Menu; Adding an ARP Table Entry {ARP Add

ACCESS GATEWAY
208 System Administration
System Menu
Adding an ARP Table Entry {ARP Add}
ARP (Address Resolution Protocol) is used to dynamically bind a high level IP address to a
low level physical hardware (MAC) address. ARP is limited to a single physical network that
supports hardware broadcasting. This procedure shows you how to add an ARP table entry.
1. From the Web Management Interface, click on System, then ARP Add. The Add ARP
Table Entries screen appears:
1. Enter the IP Address of the entry you are adding.
2. Enter the MAC Address of the entry you are adding.
3. Define whether this entry is:
 Static – Will only last until the next reboot
 Persistent – Will be written to the current.txt file and loaded on each boot of the NSE
4. Define whether the interface that the device the ARP entry is connected to is:
 Network – WAN Interface
 Subscriber 1 – LAN 1 Interface
 Subscriber 2 – LAN 2 Interface
5. Click on the Add button to add your entry, or click on the Reset button if you want to reset
all the values to their previous state.