ACCESS GATEWAY
32 Installing the Access Gateway
When using the CLI, if a procedure asks you to “enter sn,” this means you must type sn and
press the
Enter key. The system does not accept data or commands until you hit the Enter key.
Menu Organization (Web Management Interface)
When you have successfully installed and configured the Access Gateway from the CLI, you
can then access the Access Gateway from its embedded Web Management Interface (WMI).
The WMI is easier to use (point and click) and includes some items not found in the CLI. You
can use either interface, depending on your preference.
For a complete description of all features available in the WMI, see “Using the Web
Management Interface (WMI)” on page 52.
The following “composite” screen shows how the Access Gateway’s WMI menus (folders) are
organized (shown here side-by-side for clarity and space). See also, About Your Product
License.
To Next Page
Loading...
