Nomadix Access Gateways - Chapter 2: Installing the Access Gateway

ACCESS GATEWAY
1
Installing the Access Gateway 25
Installing the Access Gateway
This section provides installation instructions for the hardware and software components of the
Access Gateway. It also includes an overview of the management interface, some helpful hints
for system administrators, a Quick Reference Guide, and procedures for the following tasks:
 “Unpacking the Access Gateway” on page 26
 “Powering Up the System” on page 28
 “Logging In to the Command Line Interface” on page 29
 “Establishing the Start Up Configuration” on page 36
 “Logging Out and Powering Down the System” on page 44
 “Connecting the Access Gateway to the Customer’s Network” on page 44
 “Establishing the Basic Configuration for Subscribers” on page 45
 “Archiving Your Configuration Settings” on page 48
 “Installing the Nomadix Private MIB” on page 48
Nomadix Access Gateway
Once you have installed your Access Gateway and established the configuration
settings, you should write the settings to an archive file. If you ever experience
problems with the system, your archived settings can be restored at any time. See
“Archiving Your Configuration Settings” on page 48.