ACCESS GATEWAY
System Administration 93
2. If required, click on the check box for System Log to enable system logging.
When system logging is enabled, the standard SYSLOG protocol (UDP) is used to send all
message logs generated by the Access Gateway to the specified SYSLOG server.
3. Enter a unique number (between 0 and 7) in the System Log Number field. This ID
number is assigned to the System Log Server.
4. Enter a valid IP address in the System Log Server IP field.
5. If required, repeat Steps 2 through 4 for the AAA Log feature.
6. Setting a Log Filter: The syslogs can be filtered at 7 levels as shown above. Setting the
level to a number disables any syslogs above that filter setting. For e.g. setting the filter to
2:Critical only generates 0:Emergency, 1:Alert and 2:Critical level syslogs. All other
syslogs are not generated.
7. Log save to file Setting: This setting enables/disables saving of syslogs generated by the
system to a file named “syslog.txt” in the /flash directory of the NSE. This setting abides
by the other settings set for the syslogs like filters, number and enable/disable.
It is not required to input a server IP address if you intend to only store the syslogs locally.
Please leave the IP address field blank for such cases.
The following Logs are available for configuration on the NSE:
AAA Log
These logs record events related to Authentication, Authorization, and Accounting on the
NSE.
RADIUS History Log
These logs record RADIUS proxy accounting messages sent or received by the RADIUS
proxy. Please refer to “Viewing RADIUS Proxy Accounting Logs {RADIUS Session
History}” on page 174 for additional configuration information.
System Logs
These logs record events specific to the NSE system itself.
System Report Log
These are Periodic Syslogs that report the status of the NSE and carry information about
the NSE ID, NSE IP Address and the current number of Subscribers on the NSE.
Example:
INFO [nse_product_name version] SYSRPT: ID: 012345 IP: 11.222.333.444 (unresolved)
Subscribers: 010
Additional Configuration:
System Report Log Interval
This is the time interval in minutes between the system report syslogs.
To Next Page
Loading...
