Nomadix Access Gateways - Page 125

ACCESS GATEWAY
System Administration 113
 Fixed (for routing to predefined RADIUS servers)
3. Select the Default RADIUS Service Profile from the pull-down menu.
4. Enter a Local Authentication Port and a Local Accounting Port.
5. Select whether Later Login Supersedes Previous. This will alow a secondary form of
authentication to override MAC authentication if necessary, and use the credentials of the
last login to succeed.
See Miscellaneous Options.
Miscellaneous Options
1. In the “Miscellaneous Options” category, Enter a value for the time (in seconds) in the
Default User Idle Timeout field. This value determines how much “idle” time elapses
before the subscriber’s session times out and they must login again.
2. The Access Gateway can reauthenticate “repeat” subscribers who return to the system
within 720 hours. To enable this feature, click on the check box for
Enable Automatic
Subscriber Reauthentication
.
3. If you want to enable the URL redirection feature, click on the check box for Enable URL
Redirection
.
4. For a Network Access Server (NAS), if you want to send a NAS identifier with your
account access request, click on the check box for Send NAS identifier, then define the
NAS identifier in the
NAS identifier field.
5. To send the NAS IP address with your account request, click on the check box for Send
NAS IP
.
6. To send a NAS port type with your account request, click on the check box for Send NAS
Port type, then
define the NAS port in the NAS Port Type field.
7. To send the Framed IP address with your account request, click on the check box for Send
Framed IP
.
8. If required, check the box for Enable Session-Terminate-End-Of-Day When Authorized
(to allow business policies that want to terminate the session at midnight of every day).
9. If required, check the box for Enable Byte Count Reset On Account Start (to reset the
transmitted and received byte count for a subscriber once an “accounting start” is sent).
This function prevents counting Walled Garden traffic if the billing plan is using bytes
sent/received as a charge criterion.
10. If required, check the box for Enable RADIUS Subnet Attribute (if you want to allocate a
specific subnet to a user).
11. If required, check the box for Enable Goodbye URL (if you want the system to display a
post session “goodbye” page). The “goodbye” page can be defined as a RADIUS VSA or
be driven by the Access Gateway’s Internal Web Server (IWS).