ACCESS GATEWAY
152 System Administration
2. Enter a location identifier in the Location field. Locations can be assigned as an alpha,
numeric, or alpha-numeric value unless a PMS interface is used (see note).
3. In the Port field, enter the port (the VLAN ID when using 802.1Q 2-way).
4. In the Description field, enter a meaningful description for this port-location assignment.
5. Enter a Subnet for the port assignment you are adding.
You must now assign a State for this port-location. Possible states are, No Charge for
using this port-location, Charge for Use, and Blocked. If you do not assign a conditional
state, the state is registered as “No Charge” by default.
6. If applicable, select the Default QoS Policy for the port assignment you are adding.
7. Select the conditional state you want to assign to this port-location.
If you choose Charge for Use additional configurations are available. Refer to the
Note. Port-based Policies should be enabled from the Configuration->AAA page for
these settings to take effect.
Choose Enable RADIUS Billing if you want RADIUS billing to be enabled on this
port.
Choose Enable Tunneling if you want L2TP Tunneling based billing to be enabled
on this port.
Choose Enable PMS Billing if you want PMS based room billing to be enabled on
this port.
Choose Enable Credit Card Billing if you want Credit Card based billing to be
enabled on this port
You can select any number of billing methods per port.
A specific billing plan can be assigned to a port or all the existing billing plans defined on
the NSE can be enabled on the port. Please select the appropriate option from the
dropdown list for
Billing Plan(s) available on port.
If you are using a PMS interface, ensure that the "Location" field consists
only of numbers (no alpha characters or symbols).
All alpha characters (used for locations and descriptions) are case-sensitive.
To Next Page
Loading...
