ACCESS GATEWAY
System Administration 181
11. Define the messages you want to present to subscribers, including:
Introduction Message
Offer Message
Policy Message
12. Define the Units of Access (Minute, Hour, Day, Week, or Month) you want to make
available to subscribers.
13. If you want to allow free access to subscribers, you can define the following free billing
options:
Default Free Access Time (in days)
Maximum Subscriber Lifetime (in days)
14. Define any Promotional Code Options in the Code Definition and Percentage Discount
fields, as required. You can define up to 5 Promotional Code Options.
15. Click on the Submit button to save your changes, or click on the Reset button if you want
to reset all the values to their previous state.
Setting Up an X over Y Billing Plan
1. If required, click on the Enable check box to enable (make active) this billing plan.
2. Define a “label” for this billing plan in the Label field.
3. Enter a description for this billing plan in the Description of Service field.
4. Enter the cost the plan in the Plan Cost field.
5. Enter a duration value for this plan in the Plan Duration (X) field.
6. Define the “time unit” for the duraction value you entered in Step 5. The time unit can be
defined as either
Minute, Hour, or Day.
7. Enter plan validity value for this plan in the Plan Validity (Y) field.
8. Define the “time unit” for the plan validity value you entered in Step 7. The time unit can
be defined as either
Day, Week, or Month.
9. Define the Up (to network) and Down (to subscribers) bandwidth range for this billing
plan.
The “Percentage Discount” parameter must be between 1 and 100.
Each plan must have a unique label, different from other plans.
To Next Page
Loading...
