ACCESS GATEWAY
218 System Administration
3. In the Manager Login field, enter a login name for this manager.
4. In the Manager Password field, enter a password for this manager.
5. In the Confirm Password field, enter the password again to confirm it.
6. If you enabled Administration Concurrency, repeat steps 3 to 5 for an operator login.
As part of its Smart Client feature, the Access Gateway offers a remote RADIUS testing
feature (enabled by default). With this feature, the Access Gateway provides a password-
protected Web page. From this Web page, technical support can type a username and
password and instruct the Access Gateway to send a RADIUS access request to the
RADIUS server—following the same basic rules as if the request was from a user. The
URL for the test page is
http://<Nomadix Access Gateway IP>/radtest/testradius.htm
and can be accessed from the network side of the Access Gateway. You must open a
separate browser to utilize this feature. The “Framed IP” field is configurable by the user
and can be set to any IP address.
7. Click on the check box for Radius Authentication Enable to enable the Centralized
Authentication mechanism. If chosen, the system will first try to authenticate against the
local database and then will check against the RADIUS Service Profiles that are
configured.
8. Select the RADIUS Service Profile from the pop-up list. The list of available profiles is
defined in Realm-Based Routing.
9. Enter a Session Timeout value in minutes. This defines the time of validity period of the
cookie passed to the Web browser from the WMI Session and RADIUS session.
Login names and passwords are case-sensitive. Use login names and passwords
that are easy to remember (up to 11 characters, any character type).
If you forget your password, you will need to contact technical support. See
also, “Appendix A: Technical Support” on page 297.
To Next Page
Loading...
