Nomadix Access Gateways - Page 77

ACCESS GATEWAY
System Administration 65
2. For Configurable Ports, enter a Telnet Port and an HTTP Port.
3. Enable or disable administrator access to any of the following interfaces:
 Telnet Access
 Web Management Access (HTTP)
 Web Management Access (HTTPS)
 FTP Access
 SFTP Access
 SSH Shell Access
4. Enable or disable subscriber-side interface blocking for any of the following interfaces
 Telnet Access: enables/disables blocking of Telnet access from the subscriber-side
to the NSE Telnet interface. Default setting is enabled.
 Web Management Access (HTTP): enables/disables blocking of Web Management
access from the subscriber-side to the NSE WMI. Default setting is enabled.
 Web Management Access (HTTPS): enables/disables blocking of secure Web
Management access from the subscriber-side to the NSE WMI. Default setting is
enabled.
 FTP Access: enables/disables blocking of FTP access from the subscriber-side to the
NSE. Default setting is enabled.
 SFTP Access: enables/disables blocking of SFTP access from the subscriber-side to
the NSE. Default setting is enabled.
 SSH Shell Access: enables/disables blocking of SSH shell access from the
subscriber-side to the NSE CLI. Default setting is disabled.
5. Click the check box for Access Control if you want to enable this feature, then click on
the
Submit button to save your change.
Blocking or unblocking interface access will terminate the current session.
Do not enable the blocking of all interfaces without setting up and enabling
SNMP. Enabling the blocking of all interfaces and disabling SNMP will
completely block access to the Access Gateway administration interface. For
assistance, contact Nomadix Technical Support.