Nordson ProBlue Flex - Page 14

Table of Contents
xii
Part 1128350_02
E 2020 Nordson Corporation
Appendix G
Hose/Applicator Expansion Base G-1...........................
Overview G-1..................................................
Safety G-2..................................................
Intended Use G-2............................................
Unintended Use G-2.........................................
Melter Firmware Requirements G-2.............................
Installation G-2.................................................
Installation Clearances G-3....................................
Power Requirements G-4......................................
Removing the Melter from the Sub-Base G-4.....................
Mounting the Expansion Base to the Sub-Base G-7...............
Mounting the Melter to the Expansion Base G-8..................
Connecting Expansion Base and
Sub-base Wiring to the Melter G-10..............................
Using Melter with Expansion Base in a
Water Wash Environment G-12.................................
Troubleshooting G-13............................................
General Troubleshooting G-13..................................
Troubleshooting Specific to Expansion Base G-14..................
Expansion Base Circuit Board Indicators G-15..................
I/O Declarations for the 4 Channel Temperature Control
Expansion Board G-16......................................
Block Diagrams G-17.............................................
Expansion Base Selection G-19....................................
240 Voltage - Legacy and Standard Warmup G-19.................
480 Voltage - Legacy and Standard Warmup G-20.................
Expansion Base Parts G-22.......................................
Wiring Diagrams G-24...........................................