Installation
3-3
Part 1128350_02
E 2020 Nordson Corporation
Melter Installation
WARNING! Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
Installation Tasks
The installation sequence is as follows:
1. Verify that the required environmental conditions and utilities exist.
2. Unpack and inspect the melter.
3. Mount the melter onto the parent machine or support structure.
4. Configure the electrical service.
5. Connect a compressed air supply.
6. Connect hot melt hoses and applicators.
7. Set up t he melter to work with the manufacturing process.
8. Set up the melter's inputs and outputs.
9. Installoptionalequipment.
To Next Page
Loading...
