Nordson ProBlue Flex - Sub-base Removal

ProBlue Flex 400/480 Volt Transformer
F-15
Part 1128350_02
E 2020 Nordson Corporation
Sub-base Removal
1. Loosen the two M8 socket head cap screws on the front of the chassis
using an M6 hex wrench.
Figure F-11 Remove melter from the sub-bas e
2. OpentheE-Boxenclosuredoorandremovethesideenclosurepanel.
Seefigureontheleft(E-Boxenclosuredoorandsideenclosurepanel
highlighted in grey).
Opening the E-Box enclosure door and removing the side enclosure
panel allows access to the chassis, chassis cover plate, and
chassis-to-sub-base ground wire.