Installation
3-38
Part 1128350_02
E 2020 Nordson Corporation
Output Parameters
Table 3-5 Output Parameters
Selection Functions Hardware Option Required
Disabled Output not used N/A
Temperature Ready All temp zones within 5 °F set point, no faults or alerts,
system not in setback, ready delay complete
N/A
System Run-Ready System State = Run (Temp Ready, Pump On, Patterns
Enabled)
N/A
Fill Ready Fill system is enabled and no fill faults Fill System
Temperature
Ready-Pump On
Temp Ready a nd Pump On conditions met (Does not
include other subsystems such as fill, flow or pattern) - for
legacy support
N/A
Fill Active Active fill signal causes output active Fill System
Fill Overfill Alarm Max Fill time exceeded (overfill alarm) causes output
active
Fill System
Fill Stop Fill system stop causes output active Fill System
Tank Low Adhesive level in tank low causes output active Level Sensor (Basic/Legacy)
System Alert Any active system alert causes output active
NOTE: System Alert and fault are inverted and the
check-box is selected. The invert check-box is
automatically selected on factory reset.
N/A
System Fault Any active system fault causes output active.
NOTE: System Alert and fault are inverted and the
check-box is selected. The invert check-box is
automatically selected on factory reset.
N/A
High Flow Alert Flow Monitor related alert causes output active when
above the alert limit
Flow Board and License
Low Flow Alert Flow Monitor related alert causes output active when
below the alert limit
Flow Board and License
High Flow Stop Flow Monitor related stop causes output active when
above the stop limit
Flow Board and License
Low Flow Stop Flow Monitor related stop causes output active when
below the stop limit
Flow Board and and License
Continued...
To Next Page
Loading...
