Nordson ProBlue Flex - Quick-Start; Additional Information; Experience of Installation Personnel

Installation
3-2
Part 1128350_02
E 2020 Nordson Corporation
Quick-Start
If you have already installed the melter using the Installation Guide
(P/N 1128353) that is provided inside the shipping container, and you have
no questions concerning the installation, refer to the accompanying Quick
Reference Guide (P/N 1128354) for setting up the melter using the OLED
user interface.
For detailed user interface setup instructions refer to one of the following
manuals:
- ProBlue Flex Adhesive Melter Using the OLED User Interface Manual
(P/N 1128351).
- ProBlue Flex Adhesive Melter O EM User Interface Users' Guide
(P/N 1129255).
Additional Inf ormation
This section presents installation procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information that follows most procedures.
Experience of Installation Personnel
Theinstructionsprovidedinthissectionareintendedtobeusedby
personnel who have experience in the following subjects:
S Hotmeltapplicationprocesses
S Industrial power and control wiring
S Industrial mechanical installation practices
S Basic process control and instrumentation