Safety
1-5
E 2020 Nordson Corporation
Issued 09-19
Maintenance and Repair Practices
S Allow only personnel with appropriate training and experience to operate
or service the equipment.
S Perform scheduled maintenance activities a t the intervals described in
this document.
S Relieve system hydraulic and pneumatic pressure before servicing the
equipment.
S De-energize the equipment and all auxiliary devices before servicing the
equipment.
S Use only new Nordson-authorized refurbished or replacement parts.
S Read and comply with the manufacturer's instructions and the SDS
supplied with equipment cleaning compounds.
NOTE: SDSs for cleaning compounds that are sold by Nordson are
available at www.nordson.com or by ca lling your Nordson re presentative.
S Confirm the correct operation of all safety devices before placing the
equipment back into operation.
S Dispose of waste cleaning compounds and residual process materials
according to governing regulations. Refer to the applicable SDS or
contact the authority having jurisdiction for information.
S Keep equipment safety warning labels clean. Replace worn or damaged
labels.
Equipment Safety Information
This equipment safety information is applicable to the following types of
Nordson equipment:
S hot melt and cold adhesive application equipment and all related
accessories
S pattern controllers, timers, detection and verification systems, and all
other optional process control devices
To Next Page
Loading...
