Nordson ProBlue Flex - Mounting the Transformer on the Parent Machine

ProBlue Flex 400/480 Volt Transformer
F-11
Part 1128350_02
E 2020 Nordson Corporation
Mounting the Transformer on the Parent Machine
1. SeeFigureF-7.Marktheboltpatternontheparentmachineorsupport
structureandthendrillholesforfour8mm(
5
/
16
in.) mounting bolts
(customer-supplied).
NOTE: Open the PCA tray to acces s the bolt hole location under it
(highlighted in grey in the following figure).
Figure F-7 Bolt hole location on the transformer base
2. Attach the transformer to the parent machine using four 8-mm (
5
/
16
in.)
machine scre ws. Make sure the screws securely fasten the transformer
to the support structure.