Nordson ProBlue Flex - Preparing the 400;480 V Melter for Installation on the Transformer

ProBlue Flex 400/480 Volt Transformer
F-14
Part 1128350_02
E 2020 Nordson Corporation
Preparing the 400/480V Melter for Installation on the Transformer
WARNING! Risk of personal injury or equipment damage. Installation of the
melter requires two people.
Before installing the melter on the transformer, locate the installation kit and
inspect the melter for damaged and missing parts. Report any problems to
your Nordson representative.
The 400/480V ProBlue Flex melters come with the sub-base factory installed.
Prior to mounting the melter onto the transformer, be sure to remove the
sub-base from the melter.
1
2
3
Figure F-10 Melter with the chassis and sub-base
1. ProBlue Flex melter
2. Sub-base
3. Chassis