Nordson ProBlue Flex - I;O Declarations on the ATS Board

Adhesive Tracking System
D-8
Part 1128350_02
E 2020 Nordson Corporation
I/O Declarations on the ATS Board
SeeFigureD-1fortheATSboard.
Connector Terminals Type Rating Use
X2, X4 1-8
Standard
RJ45
Ethernet
10/100
Ethernet
TB1, T B2
1 24VDC
Input/Output
24VDC @
650 mA
Used to supply 24VDC to the ATS board. Two identical
connectors provided so power can be daisy-chained to
other expansion boards.
TB3 1, 4 Inductive
sensor
inputs
3.3V logic The inductive sensor attached completes an RLC
oscillator. The frequency shifts slightly when a flow meter
gear tooth passes by the sensor.
TB3 2, 3, 5, 6 Circuit
Common
Circuit
Common
TB4 1 24VDC
Output
24 VDC @
100 mA
TB4 2 Analog
input signal
0-10V;
4-20 mA
Line speed input signal provided by customer.
TB4 3, 4 Circuit
Common
Circuit
Common
TB5 1 24VDC
Output
24 VDC @
200 mA
24VDC provided to power external encoder device.
TB5 2, 3, 4, 5 Encoder
signals
24VDC
logic
Inputs for quadrature, differential encoder signals.
TB5 7, 8 Circuit
Common
Circuit
Common
TB6 1 Ejector 24V
output
24VDC @
300 mA
Ejector output used by customer to signal bad products
TB6 2, 5, 6, 9, 10 Circuit
Common
Circuit
Common
TB6 3, 7 24VDC
Output
24 VDC @
100 mA
24VDC provided to power external photosensor device.
TB6 4, 8 Trigger
inputs
24VDC
logic
Input for photosensor signal. Can support NPN (sinking)
or PNP (sourcing) signals.