Nordson ProBlue Flex - Page 4

Table of Contents
ii
Part 1128350_02
E 2020 Nordson Corporation
Installation 3-1................................................
Overview 3-1..................................................
Quick-Start 3-2................................................
Additional Information 3-2.....................................
Experience of Installation Personnel 3-2.........................
Melter Installation 3-3...........................................
Installation Tasks 3-3........................................
Installation Requirements 3-4....................................
Melter Clearances 3-4........................................
Ventilation 3-6..............................................
Electrical Power 3-6..........................................
Compressed Air 3-7.........................................
Melter Mounting Considerations 3-8............................
Unpack the Melter 3-9..........................................
Contents of the Installation Kit 3-9..............................
Customer-Supplied Materials 3-10..............................
Mount the Melter 3-10...........................................
Removing the Melter from the Sub-base 3-11.....................
Mounting the Melter 3-15......................................
Connecting Incoming Power 3-16...............................
Configure the Electrical Service 3-17...............................
Melter Power Requirements 3-17...............................
4 Kg Tank (T04, X04) 3-17...................................
7 Kg and 10 Kg Tank (T07, X07, T10, X10) 3-18................
7 Kg/Hr MOD (M07, Z07) 3-18...............................
14 Kg/Hr MOD (M14, Z14) 3-19..............................
15 Kg Tank (T15, X15) 3-19..................................
21 Kg/Hr MOD (M21, Z21) 3-20..............................
Connecting Power Cables 3-21.................................
Connect a Pump Control Signal 3-25...............................
Connecting Power to the Solenoid Valve 3-26.....................
Single Acting Pump Operation Notes 3-27.......................
Connect a Compressed Air Supply 3-28............................
Connect Hoses and Applicators 3-31..............................
Connecting the Hoses 3-31....................................
Connecting the Applicators 3-34................................
Set Up the Melter 3-35...........................................
Using the OLED User Interface 3-35.............................
Set Up the Melter Inputs and O utputs (I/O) 3-36.....................
I/O Connections 3-36.........................................
Input Parameters 3-37.........................................
Output Parameters 3-38.......................................
Install Optional Accessories 3-40..................................